Engine shaft taper

29.05.2019   |   by Mataxe

Views: 24 985

Comments "engine shaft taper":

Author: Megore
How smooth was the cut.  I would think that it would vibrate a lot.
Author: Tutaxe
So was the chuck clamped onto the honda flywheel? Or was the honda motor bolted to the lathe carriagewithout being attached to the chuck? Trying to fig out how you bolted the thing down
Author: Kegul
without the key way being filled by the key. you are giving the engine an un balanced shaft.
Author: Zujinn
hi jimI have the opposite problem, I have a 20 hp Honda with a tapered shaft looking to make it a straight shaft, would your lathe be able to straighten it out?  thanks
Author: Mudal
i wish we all could have the measurements
Author: Duzuru
good thinking Batman  i like it there are no rules when it comes to engineering
Author: Nikokree
It may have been easier to drill out the pulley and make it strait?
Author: Nikojar
Clever
Author: Feran
Jim I have a engine with taper shaft - is there a adapter or sleeve that could be retro fitted to use the engine as a straight shaft. Like you I don't want to or have the

Recent Comments